• LCDA-EP

The remote LCD displays connects only to WNB Series Pulse Output WattNode® meters to display power (watts or kilowatts) and/or energy (kilowatt-hours). The display can be mounted in a rectangular cutout on the front of a service panel, junction box, or any other panel up to 0.2 in. (5mm) thick. Using the adjustable decimal point and scale factor, you can display almost any desired resolution or range.

  • Pulse Input - Compatible with P-Series WattNodes pulse output meters.
  • Panel Mount - Meets NEMA-4X when used with provided gasket.
  • Four Year Battery Life - Uses 3 volt lithium battery.
  • Eight Digits - Large 0.43" (11 mm) digits.
  • Backlighting Available - Requires 10-30 Vdc power supply.

The energy display shows accumulated watt-hours (Wh), kilowatt-hours (kWh) or megawatt-hours (MWh). The scale factor and decimal point can be adjusted to display in the following units: WH, hundredths of kWh, tenths of kWh, kWh, or thousandths of MWh. With appropriate scale factors, the display overflow interval (from all 9's back to 0) can be set from less than a year to over a hundred years.
The power display shows the current power consumption in watts or kilowatts.
The combo display toggles between displaying power and energy at the press of a button.
The energy total can be reset either by pressing the 'RST' button or with a remote wired reset button. To prevent unauthorized resetting, the front panel reset button can be disabled. The remote reset connects to the rear screw terminals. If a locking NEMA enclosure is used, then a key switch can be connected to the remote reset, allowing reset only with the use of a key.

This product is made-to-order from the factory.  As a result you may experience a short delay in receiving your product.  For exact lead times please contact Opto Solutions.


Write a review

Note: HTML is not translated!
    Bad           Good

LCDA-EP

  • $175.00


´╗┐